Install in Demo mode on MacOS and LinuxEdit on GitHub
Starting with the 202204.0 release, the following guide applies to both Intel and ARM architectures. You can install the demo shops of previous versions on ARM chips by following Switch to ARM architecture.
This document describes how to install Spryker in Demo Mode on MacOS and Linux.
Install Docker prerequisites on MacOS and Linux
Clone a Demo Shop and the Docker SDK
Open a terminal.
Clone one of the following Demo Shops and navigate into its folder:
- B2C Demo Shop:
git clone https://github.com/spryker-shop/b2c-demo-shop.git -b 202311.0 --single-branch ./b2c-demo-shop && \ cd b2c-demo-shop
- B2B Demo Shop:
git clone https://github.com/spryker-shop/b2b-demo-shop.git -b 202311.0 --single-branch ./b2b-demo-shop && \ cd b2c-demo-shop
- B2C Marketplace Demo Shop
git clone https://github.com/spryker-shop/b2c-demo-marketplace.git -b 202311.0 --single-branch ./b2c-demo-marketplace && \ cd b2c-demo-marketplace
- B2B Marketplace Demo Shop
git clone https://github.com/spryker-shop/b2b-demo-marketplace.git -b 202311.0 --single-branch ./b2b-demo-marketplace && \ cd b2b-demo-marketplace
Clone the Docker SDK:
git clone https://github.com/spryker/docker-sdk.git --single-branch docker
Configure and start the instance
- Bootstrap the local Docker setup for demo:
Once you finish the setup, you don’t need to run
bootstrap to start the instance. You only need to run it after updating the Docker SDK or changing the deploy file.
- Update the hosts file using the command provided in the output of the previous step. It should be similar to the following:
- Build and start the instance:
Depending on the hardware performance, the first project launch can take up to 20 minutes.
To ensure that the installation is successful, make sure you can access the configured endpoints from the Deploy file. For more information about the Deploy file, see Deploy file reference.
The default credentials to access the Back Office are located inside
To access RabbitMQ UI, use
spryker as a username and
secret as a password. You can adjust the credentials in
deploy.yml. For information about the Deploy file, see Deploy file reference.
Get the list of useful commands
To get the full and up-to-date list of commands, run
For submitting the form